مقطورة نصف منخفضة

Fliegl SDS 470 T Standard

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer requirements.

Chassis, low-bed semi-trailer
Steel welded construction, kingpin plate with 2 replaceable kingpins and 2 kingpin positions,
24 tons, 2-speed landing gear, single-sided operation, with straight lower section, without thrust compensation
Rear support, foldable
2 wheel chocks with holder
Aluminum side impact protection
Mud flaps at the rear, covering the entire width
Fenders in front of the 1st axle and at the rear of each axle with anti-spray, according to EC
Extendable widening elements to 3,000 mm (not in rear slope)
Storage compartment for timber planks in the center of the loading area
Timber planks 70 mm for widening to 3,000 mm
Tie-down points, low-bed
2 pairs of ring tie-down points, each 5 tons, at the front on the gooseneck
11 pairs of tie-down mushroom heads, recessed at the top and side in the outer frame, each 10 tons
2 x on the gooseneck
9 x distributed in the low-bed area
First tie-down point 250 mm from the front and last max. 250 mm from the rear, distance between tie-down points not greater than 1100 mm
8 pairs of beam pockets recessed in the outer frame, inner dimensions 70 x 40 mm (can be converted to 5 ton ring tie-down points)
Axles + Suspension
SAF drum brake axles
Air suspension
Wheels and tires
235 / 75 R 17.5
Steel rims in twin arrangement, factory silver
Braking system
Dcsdpfxei Ri E Rj Aitjn
2-line compressed air brake system
Color-coded line routing for easy service.
Spring parking brake
EBS, electronic brake system with EBS socket at the front, without connection cable
2 fail-safe coupling heads at the front, without connection cable
with lift and lower valve
Axle load recognition via EBS-CAN bus signal, for display on the instrument panel in the cab
Vehicle - driving stability system
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red outline marker lights at the rear
2 x 7-pole fail-safe sockets at the front, without connection cable
1 LED rotating beacon with holder
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Gooseneck with steel sheet covering
Storage box recessed in the ramp to the gooseneck
followed by 70 mm softwood floor, in the wheel arch area steel/diamond plate covering
Rear slope with 70 mm softwood floor
Low-bed area including rear slope 9,200 mm
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally adjustable
covered with wood
Hydraulically operated via tractor's auxiliary drive with throttle, operation on the left side
Hydraulic connection with SVK socket NW 10/3, without connecting hoses

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer requirements.

تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.