مقطورة مع منصة عملMÜLLER-MITTELTAL
14,4 to, Tand - Plateau- Tieflader, hydr. Rampen
مقطورة مع منصة عمل
MÜLLER-MITTELTAL
14,4 to, Tand - Plateau- Tieflader, hydr. Rampen
سعر ثابت بالإضافة إلى ضريبة القيمة المضافة
30.900 €
(36.771 € إجمالي)
سنة الصنع
2026
الحالة
جديد
الموقع
Egestorf 

البيانات الأساسية
السعر والموقع
سعر ثابت بالإضافة إلى ضريبة القيمة المضافة
30.900 €
(36.771 € إجمالي)
- الموقع:
- Eichenstich 12, 21272 Egestorf, Deutschland

اتصل
تفاصيل فنية
- الوزن الأقصى للحمولة:
- 10.800 كجم
- الوزن الإجمالي:
- 14.400 كجم
- تكوين المحور:
- محورين
- طول مساحة التحميل:
- 6.270 مم
- عرض مساحة التحميل:
- 2.470 مم
تفاصيل العرض
- معرّف الإعلان:
- A152-72-860
- رقم المرجع:
- 6247a
- تحديث:
- آخر مرة في ٠٨.٠٥.٢٠٢٦
وصف
* ETÜ-TA-R 14.4:
----Brakes:
* EBS brake system
* Emergency release device for spring-loaded brake cylinders
* Drum brakes
----Axles:
* 2 x 7 t Gigant axles
----Suspension:
* Parabolic springs with compensating unit
----Drawbar / Flange Towing Eye:
* Drawbar height-adjustable by 300 mm
* Drawbar extension by 250 mm to a total length of 2,250 mm
----Electrics / Lighting:
* Tire pressure monitoring system with in-cab display via EBS signal (no truck-side installation required)
* 15-pin power connector
* LED lighting system 12 / 24 V
* EBS multi-voltage system for towing vehicles with 12 and 24 V electrics
----General Attachments:
* Support winch at the front
* External folding support legs at the rear
* Plastic toolbox approx. 858 x 500 x 500 mm mounted front right on the bulkhead
* Side underrun protection
* Plastic quarter mudguards
----Low Loader Deck:
* 50 mm softwood floor
* Provision in front of the bulkhead for retrofitting container locks
* Bolted 400 mm high smooth steel bulkhead
* Bolted rear posts
* Drop sides with spring assist
----Load Securing:
* Perforated outer frame, approximately 45° angled, with 2 t lashing capacity every 480 mm
* Option to install 3 t recessed lashings every 600 mm
Ppedpfx Anerwc R Rsiot
* One 6.3 t lashing ring in each front and rear corner
* Various holes for 1.2 t lashing points in the front and rear crossmembers
* Profifix lashing rail, centered lengthways, for lashing up to LC 3,000 daN
----Ramps:
* One-piece hydraulic mesh loading ramps, approx. 2,750 x 600 mm (collapsible to 20 mm clearance)
* Hydraulic flow divider installed in trailer (for hydraulic pump flow from the truck exceeding 40 l/min up to max. 140 l/min)
----Paintwork:
* Chassis, drawbar, bulkhead, mechanical folding supports, and loading ramps hot-dip galvanized
* Axles, springs, air tanks, front support winch, and flange towing eye painted black
* Drop side panels painted in RAL 9010 pure white
* Painting of side panels in any RAL color available at extra cost
----Information:
* New vehicle with manufacturer warranty
* Subject to misprints and prior sale
----Delivery time:
* Immediately available ex-works Egestorf
تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.
----Brakes:
* EBS brake system
* Emergency release device for spring-loaded brake cylinders
* Drum brakes
----Axles:
* 2 x 7 t Gigant axles
----Suspension:
* Parabolic springs with compensating unit
----Drawbar / Flange Towing Eye:
* Drawbar height-adjustable by 300 mm
* Drawbar extension by 250 mm to a total length of 2,250 mm
----Electrics / Lighting:
* Tire pressure monitoring system with in-cab display via EBS signal (no truck-side installation required)
* 15-pin power connector
* LED lighting system 12 / 24 V
* EBS multi-voltage system for towing vehicles with 12 and 24 V electrics
----General Attachments:
* Support winch at the front
* External folding support legs at the rear
* Plastic toolbox approx. 858 x 500 x 500 mm mounted front right on the bulkhead
* Side underrun protection
* Plastic quarter mudguards
----Low Loader Deck:
* 50 mm softwood floor
* Provision in front of the bulkhead for retrofitting container locks
* Bolted 400 mm high smooth steel bulkhead
* Bolted rear posts
* Drop sides with spring assist
----Load Securing:
* Perforated outer frame, approximately 45° angled, with 2 t lashing capacity every 480 mm
* Option to install 3 t recessed lashings every 600 mm
Ppedpfx Anerwc R Rsiot
* One 6.3 t lashing ring in each front and rear corner
* Various holes for 1.2 t lashing points in the front and rear crossmembers
* Profifix lashing rail, centered lengthways, for lashing up to LC 3,000 daN
----Ramps:
* One-piece hydraulic mesh loading ramps, approx. 2,750 x 600 mm (collapsible to 20 mm clearance)
* Hydraulic flow divider installed in trailer (for hydraulic pump flow from the truck exceeding 40 l/min up to max. 140 l/min)
----Paintwork:
* Chassis, drawbar, bulkhead, mechanical folding supports, and loading ramps hot-dip galvanized
* Axles, springs, air tanks, front support winch, and flange towing eye painted black
* Drop side panels painted in RAL 9010 pure white
* Painting of side panels in any RAL color available at extra cost
----Information:
* New vehicle with manufacturer warranty
* Subject to misprints and prior sale
----Delivery time:
* Immediately available ex-works Egestorf
تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.
مورد
ملاحظة: سجّل مجانًا أو سجّل الدخول، للاطلاع على جميع المعلومات.
مسجل منذ: 2001
170 إعلانات عبر الإنترنت
إرسال طلب
هاتف & فاكس
+49 40 33... إعلانات
قد تهمك أيضًا هذه الإعلانات.
تم حذف إعلانك بنجاح
حدث خطأ
































































