مقطورة نصف منخفضةFAYMONVILLE
MAX Trailer MAX100 Semi-Tieflader 2tlg. Rampen
مقطورة نصف منخفضة
FAYMONVILLE
MAX Trailer MAX100 Semi-Tieflader 2tlg. Rampen
الحالة
جديد
الموقع
Essen 

البيانات الأساسية
السعر والموقع
- موقع البائع:
- Heegstraße 6-8, 45356 Essen, ألمانيا

اتصل
تفاصيل فنية
الأبعاد والوزن
الوزن الإجمالي:
73.000 كجم
الوزن الأقصى للحمولة:
58.860 كجم
محاور وعجلات
تكوين المحور:
٣ محاور
ميزات الأمان
نظام الفرامل المانعة للانغلاق (ABS)
تفاصيل العرض
- معرّف الإعلان:
- A233-66-665
- رقم المرجع:
- 38054
- تحديث:
- آخر مرة في 21.11.2026
وصف
You can find our complete vehicle inventory, including vehicles available for immediate and short-term delivery, on our website. Below is an excerpt of the equipment. Complete equipment list available upon request.
GOOSENECK
Gooseneck with angled front corners at 45° and rear angle of approximately 750 mm x 10°.
3 pairs of lashing rings (LC 5,000 daN).
Hardwood decking, approximately 30 mm thick.
- 2-inch kingpin
- One galvanized steel front panel, approximately 400 mm high.
LOADING PLATFORM
Loading platform in extendable design with rear angle of approximately 500 mm x 8°.
8 pairs of lashing rings, foldable outwards (LC 10,000 daN).
Kdedpfe Aldaljx Ag Asw
1 pair of lashing rings, located horizontally at the front of the loading platform (LC 10,000 daN).
Cutouts in the outer frame of the loading platform for attaching lashing straps (LC 2,000 daN).
Hardwood decking, approximately 48 mm thick, with non-slip steel plate decking over the axles.
- On the gooseneck and at the rear, one bracket on the left and right sides for warning signs, including a socket.
- One bracket for a rear marker light at the rear of the trailer.
- Galvanized supports under the angle of the loading platform.
- Electro-hydraulic unit at the rear, under the loading platform (± 45 kg).
HYDRAULIC LOADING RAMPS
One pair of galvanized, two-piece steel ramps, approximately 2,750 + 1,400 x 900 mm, with Super Grip rubber surface.
Ramps with hydraulically extendable and foldable ramp sections.
Hydraulic lifting mechanism, hydraulically movable.
Maximum load per pair: 50,000 kg
- Super Grip 25 rubber surface in the angle of the loading platform.
- Cover plates to bridge the gap between the ramps and the loading platform (± 17 kg).
FIFTH WHEEL LANDING GEAR
JOST fifth wheel landing gear, mechanical, with a 2-speed gear for an approximate lifting capacity of 24 tons (approx. 50 tons test load).
TIRES
Tires 235/75 R17.5 3PMSF - Manufacturer of our choice
TPMS
TPMS tire pressure monitoring system according to ECE R 141.
AXLES
BPW axles and suspension, 1st axle with steering knuckle, 2nd + 3rd axle rigid, 4th + 5th axle with steering knuckle.
Technical axle load: 12,000 kg each.
1st, 4th, and 5th axles with electromagnetic reverse lock via reverse gear and manually activated.
BRAKE SYSTEM
WABCO brake system according to EU regulations with EBS-E (2S2M)
PAINTING
HRM metallization of the entire vehicle chassis with ZINACOR 850 (85% zinc/15% aluminum) to ensure the best corrosion protection.
Trailer, carmine red (RAL 3002)
Incl. accessories
On the gooseneck, aluminum side and rear panels, plug-in design, approximately 2,440 x 400 mm (L x H).
The rear galvanized plug-in uprights are removable. (Length of the superstructure approx. 2,560 mm). (± 46 kg)
One galvanized toolbox, integrated into the angled gooseneck (± 47 kg).
3 pairs of WADER container pockets in the loading platform for a 20' (30') or 40' container. (± 30 kg)
6 pairs of upright pockets for plug-in uprights, approximately 100 x 50 mm, in the outer frame of the loading platform. (± 18 kg)
Extensions, galvanized, extendable by approximately 230 mm on each side (± 262 kg).
Lift axle on the front axle with control via TEBS E, depending on the current axle load and the current loading condition (± 69 kg).
تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.
GOOSENECK
Gooseneck with angled front corners at 45° and rear angle of approximately 750 mm x 10°.
3 pairs of lashing rings (LC 5,000 daN).
Hardwood decking, approximately 30 mm thick.
- 2-inch kingpin
- One galvanized steel front panel, approximately 400 mm high.
LOADING PLATFORM
Loading platform in extendable design with rear angle of approximately 500 mm x 8°.
8 pairs of lashing rings, foldable outwards (LC 10,000 daN).
Kdedpfe Aldaljx Ag Asw
1 pair of lashing rings, located horizontally at the front of the loading platform (LC 10,000 daN).
Cutouts in the outer frame of the loading platform for attaching lashing straps (LC 2,000 daN).
Hardwood decking, approximately 48 mm thick, with non-slip steel plate decking over the axles.
- On the gooseneck and at the rear, one bracket on the left and right sides for warning signs, including a socket.
- One bracket for a rear marker light at the rear of the trailer.
- Galvanized supports under the angle of the loading platform.
- Electro-hydraulic unit at the rear, under the loading platform (± 45 kg).
HYDRAULIC LOADING RAMPS
One pair of galvanized, two-piece steel ramps, approximately 2,750 + 1,400 x 900 mm, with Super Grip rubber surface.
Ramps with hydraulically extendable and foldable ramp sections.
Hydraulic lifting mechanism, hydraulically movable.
Maximum load per pair: 50,000 kg
- Super Grip 25 rubber surface in the angle of the loading platform.
- Cover plates to bridge the gap between the ramps and the loading platform (± 17 kg).
FIFTH WHEEL LANDING GEAR
JOST fifth wheel landing gear, mechanical, with a 2-speed gear for an approximate lifting capacity of 24 tons (approx. 50 tons test load).
TIRES
Tires 235/75 R17.5 3PMSF - Manufacturer of our choice
TPMS
TPMS tire pressure monitoring system according to ECE R 141.
AXLES
BPW axles and suspension, 1st axle with steering knuckle, 2nd + 3rd axle rigid, 4th + 5th axle with steering knuckle.
Technical axle load: 12,000 kg each.
1st, 4th, and 5th axles with electromagnetic reverse lock via reverse gear and manually activated.
BRAKE SYSTEM
WABCO brake system according to EU regulations with EBS-E (2S2M)
PAINTING
HRM metallization of the entire vehicle chassis with ZINACOR 850 (85% zinc/15% aluminum) to ensure the best corrosion protection.
Trailer, carmine red (RAL 3002)
Incl. accessories
On the gooseneck, aluminum side and rear panels, plug-in design, approximately 2,440 x 400 mm (L x H).
The rear galvanized plug-in uprights are removable. (Length of the superstructure approx. 2,560 mm). (± 46 kg)
One galvanized toolbox, integrated into the angled gooseneck (± 47 kg).
3 pairs of WADER container pockets in the loading platform for a 20' (30') or 40' container. (± 30 kg)
6 pairs of upright pockets for plug-in uprights, approximately 100 x 50 mm, in the outer frame of the loading platform. (± 18 kg)
Extensions, galvanized, extendable by approximately 230 mm on each side (± 262 kg).
Lift axle on the front axle with control via TEBS E, depending on the current axle load and the current loading condition (± 69 kg).
تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.
مورد
ملاحظة: سجّل مجانًا أو سجّل الدخول، للاطلاع على جميع المعلومات.
مسجل منذ: 2003
68 إعلانات عبر الإنترنت
إرسال طلب
هاتف & فاكس
+49 201 8... إعلانات
تم حذف إعلانك بنجاح
حدث خطأ




















