مقطورة منخفضة التحميل

FLIEGL DTL 300 3-Achs Tieflader Agrar Greenl. Hydraulik

Gross weight: 24,000kg / 30,000kg
Tare weight: 5,600kg
Payload: 18,400 / 24,400kg
Total length: 10,290mm
Loading length: 5,900mm including rear incline
Width: 2,520mm
Loading height: 860mm
Further information
plus pre-carriage / preparation ex storage location 26639 Wiesmoor €1,280.00 / net

Chassis Lowbed Trailer
Steel welded construction
Turntable with heavy-duty ball-bearing slewing ring
Rear supports foldable
2 wheel chocks with holder
Rear mudflaps across entire width (not compatible with forklift holder)
1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable
Prepared for extensions to 3,000 mm (holes in outer frame with cover, not in the rear incline)
Lashing points low loader
1 pair lashing cutouts in front longitudinal beam embedded in the goose neck, each 10t
7 pairs of lashing mushrooms recessed into the outer frame, each 10t (top and side)
1x at the front on the goose neck
5x in the lowbed
1x in the rear incline
12 pairs of lashing holes in the outer frame, 5t each (for securing straps)
5x on the goose neck, 6x lowbed, 1x rear incline
Drawbar turntable coupling
Drawbar with certified 40 mm towing eye
Drawbar height adjustment by spring
Axles & suspension
Drum brake axles, according to manufacturer's choice
"Axles/chassis laser-measured" to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load equalization (rocker equalization)
Wheels and tires
235/75 R 17.5''
manufacturer's selection
Steel rims in twin arrangement, factory silver
Braking system
2-line compressed air braking system
Spring-loaded parking brake
2 foolproof coupling heads at the front, with connecting lines to the towing vehicle, lines extended by approx. 60 cm
without ABS, but with mechanical ALB, then max. 60 km/h approval
Electrics
12 Volt, multi-chamber lamps, without side yellow LED lighting, side reflectors
2 white position lights at front
2 white/red marker lights at rear
1x 7-pole 12 Volt plug at front, with extension cable, extended by approx. 60 cm
1 LED beacon with holder, switched via parking light (removable beacon)
2 pairs of warning boards, illuminated and extendable to 3,000 mm
Floor
Gooseneck area with steel / checker plate covering
Toolbox recessed into transition to goose neck
then approx. 70 mm softwood floor, steel/checker plate covering in wheel arch area
Hjdpjynvrwsfx Ab Eei
Rear incline with 70 mm softwood floor
Lowbed area incl. rear incline 5,900 mm
Loading ramps
Steel ramps approx. 3,000 mm long, 750 mm wide, laterally slidable
covered with wood (tip area steel/checker plate)
Hydraulically operated via tractor PTO with throttle, control on driver’s side left
Hydraulic connection with SVK plug NW 10/3, incl. connecting hose
Operating instructions
For 10,000 kg axle load, exemption required, indivisible load only!!!
The specified gross weight is technically feasible, depending on cargo the gross weight may not be achievable due to axle/support/kingpin load limits. (Poor driving and tracking behavior due to incorrect load distribution possible)
Country of registration / Plates
Registration country: Germany
with Dekra approval and certificate, for max. 60 km/h registration, towing vehicle LoF (agriculture/forestry), (Switzerland: max. 40 km/h possible)
prepared for two-line license plate holder
without contour marking / reflective tape per ECE R 048
Paintwork
Frame hot-dip galvanized incl. passivation
“15-year warranty against through corrosion” (text incomplete)

تمت ترجمة الإعلان تلقائياً، وقد تكون هنالك بعض الأخطاء في الترجمة.