مقطورة محملة منخفضة

FLIEGL DTL 300 Agrar Greenlight Hydraul. 3-Achs Tieflad

Total weight: 24,000kg/30,000kg
Payload: 18,400kg/24,400kg
Total length: 10,290mm
Loading length: 5,900mm low bed including rear bevel / 2,170mm offset

Further information

plus pre-freight / provision from storage location 26639 Wiesmoor 1,280.00 €/net

Chassis low bed trailer
Steel welded construction
Turntable with strong ball bearing ring
Foldable rear support
Wheel chocks with holder
Without side impact protection
Rear mud flaps across the entire width (not in conjunction with forklift bracket)
Without mudguards
1 plastic tool box, with shelf, w=620/h=360/d=440 mm, lockable with a padlock.
(Lock not included)
Preparation for widening to 3,000 mm (holes in the outer frame and not in the rear bevel)
Lashing eyes for low loader
1 pair of lashing cutouts in the longitudinal member at the front on the offset, 10 tonnes each.
7 pairs of lashing mushrooms at the top and sides of the outer frame, 10 tonnes each
1 x at the front on the offset
5 x in the low bed
1 x in the rear bevel
12 pairs of lashing holes in the outer frame, 5 tonnes each. (tension belt attachment)
5 x offset, 6 x low bed and 1 x in rear bevel

Towbar with tested 40 mm towing eye

Axles + suspension
Drum brake axles, at the manufacturer's choice
"Axle/chassis laser measured" Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation
(rocker compensation)

Wheels and tires
Ugx8Voahjf
235 / 75 R 17.5"
at the manufacturer's choice
Twin steel rims, factory silver

Brake system
2-line compressed air brake system
Spring-loaded parking brake
2 interchangeable coupling heads at the front, with connecting lines to the motor vehicle,
Connecting lines extended by approx. 60 cm
Without ABS, but with mechanical ALB, then max. 60 km/h approval

Electrics
12 volt, multi-chamber lights, without yellow LED lighting on the side, reflectors on the side
2 white position lights at the front
2 white/red lane keeping lights at the rear
1 x 7-pin 12 volt plug at the front, with connecting cable, extended by approx. 60 cm
1 LED rotating beacon with holder, switched via parking light (light removable)
2 pairs of warning signs illuminated and extendable to 3,000 mm

Floor
Front bend with steel/checker plate covering
Storage box embedded in the crossing slope to the bend
then with 70 mm softwood floor, steel/checker plate covering in the wheel arch area
Rear bevel with 70 mm softwood floor
Low loading area including rear bevel 5900 mm

Drive-on ramps
Steel ramps 2,800 mm long, 750 mm wide, can be moved sideways
covered with wood (tip area with Steel/checker plate)
Hydraulic via tractor auxiliary drive with throttle, actuation on the side in FR left
Hydraulic connection with SVK connector NW 10/3, including connecting hose
Frame hot-dip galvanized including passivation

تمت ترجمة الإعلان تلقائياً، وقد تكون هنالك بعض الأخطاء في الترجمة.